Graco Edge HVLP Quick Release Fluid Sets

Maximize your spraying performance with the Graco HVLP EDGE HVLP Gun by using the correct needle & nozzle size for the material being sprayed. Graco Edge Quick Release Fluid Sets are designed for quick changing on the job without the need for tools.

Quick Release Needle Design

• Change out needles from the front of the gun with just a click
• Easy to change, easy to clean with no tools needed
• Remove front air cap and nozzle
• Slide trigger lever to release needle
• Pull needle out

Quick Release Fluid Sets available for Graco Edge Guns –

• Part No. 256946         #2 Needle & Nozzle Set (0.8mm)
• Part No. 256947         #3 Needle & Nozzle Set (1.3mm)
• Part No. 256948         #4 Needle & Nozzle Set (1.8mm)
• Part No. 256949         #5 Needle & Nozzle Set (2.2mm)
• Part No. 256950         #6 Needle & Nozzle Set (2.5mm)

Choosing the correct needle & nozzle size for your Graco Edge HVLP spray gun will ensure a perfect finish. Use the guide below to select the quick release fluid set applicable to the material being sprayed.

Note – HVLP turbines produce heat in the motor warming up the air supplied to the gun, you may need to use a slower drying thinner to compensate for the faster drying time. 

AA Spray stock a full range of Graco HVLP guns, fluid sets, check valves, filters and hoses to suit all models of Graco HVLP Turbine Sprayers with fast delivery Australia wide.